.

param-docs/parameter-pages/System/Hostname.md

@@ -1,8 +1,6 @@
 # Parameter `Hostname`
 Default Value: `undefined`
-
 !!! Warning
     This is an **Expert Parameter**! Only change it if you understand what it does!
-
 Hostname for the device.
 It gets automatically transferred to `/wlan.ini` on the SD-Card at next startup.

param-docs/parameter-pages/System/RSSIThreshold.md

@@ -1,6 +1,5 @@
 # Parameter `RSSIThreshold`
 Default Value: `''`
-
 WLAN Mesh Parameter: Threshold for the RSSI value to check for start switching access point in a mesh system.
 Possible values: `-100` .. `0`, `0` = disabled.
 It gets automatically transferred to `/wlan.ini` on the SD-Card at next startup.

param-docs/parameter-pages/System/SetupMode.md

@@ -1,7 +1,5 @@
 # Parameter `SetupMode`
 Default Value: `true`
-
 !!! Note
     This parameter is not accessible through the Web Interface Configuration Page!
-
 Set this parameter to `true` to stay in the Setup Mode after the next start of the device.

param-docs/parameter-pages/System/TimeServer.md

@@ -1,9 +1,7 @@
 # Parameter `TimeServer`
 Default Value: `pool.ntp.org`
-
 !!! Warning
     This is an **Expert Parameter**! Only change it if you understand what it does!
-
 Time server to synchronize system time. If it is disabled or `undefined`, `pool.ntp.org` will be used.
 You can also set it to the IP of your router. Many routers like Fritzboxes can act as a local NTP server.
 To disable NTP, you need to activate it but set the TimeServer config to be empty (`""`).

param-docs/parameter-pages/System/TimeZone.md

@@ -1,5 +1,4 @@
 # Parameter `TimeZone`
 Default Value: `CET-1CEST,M3.5.0,M10.5.0/3`
-
 Time zone in POSIX syntax (Europe/Berlin = `CET-1CEST,M3.5.0,M10.5.0/3` - incl. daylight saving)
 Check the table on `http://<DEVICE IP>/timezones.html` to find the settings for your region.