| # AI-on-the-edge-device ## Webinstaller and Console

This page provides the Webinstaller and a live USB Console to your AI-on-the-edge-device.
For further information about AI-on-the-edge-device please go to https://github.com/jomjol/AI-on-the-edge-device.

Notes:

- For the installation, make sure to switch the ESP32 to Bootloader mode!
- Beside the firmware, also the SD-Card needs to be flashed. This can be done manually or through an initial simple access point.
  Instructions see Wiki!
- After the installation, a manual reset might be required!
- Please note that not all webbrowsers and operating systems support the needed access to USB!
- Check the Wiki for additional information.

Installer and Console powered by ESP Web Tools