mirror of
https://github.com/jomjol/AI-on-the-edge-device-docs.git
synced 2025-12-07 12:07:01 +03:00
35 lines
1.8 KiB
Markdown
35 lines
1.8 KiB
Markdown
# Initial Setup
|
|
|
|
After setting up the device (firmware, SD card, WLAN) the device will connect to the wifi access point and start in an initial setup configuration:
|
|
|
|
{: style="width:500px"}
|
|
|
|
With the buttons on the top you can navigate through 5 steps which guide you through the necessary setup:
|
|
|
|
1. Create the [Reference Image](Reference-Image.md). It is the base for the position referencing and the identification of the digits and counters.
|
|
1. Define two unique [Reference Marks](Alignment.md). They is used to align the individual camera images and identify the absolut positions.
|
|
1. Define [ROIs](ROI-Configuration.md) for the Digits. They will be used to digitize the digit part of your meter. If your meter has no digits, this step can be skipped.
|
|
1. Define [ROIs](ROI-Configuration.md) for the Analog Counters. (Only required in case your meter has analoge counters)</li>
|
|
1. [General Settings](Configuration.md). Further configuration of your device.
|
|
|
|
All settings can be accessed also later in the normal operation mode.
|
|
|
|
!!! Note
|
|
Don' t forget to save each step with "Save" and do not reboot at this stage.
|
|
|
|
## Finish the Setup and change to the Normal Operation mode
|
|
With the last step `(1)` you leave the **Setup Mode** and reboot to the **Normal Operation mode**.
|
|
|
|
{: style="width:500px"}
|
|
|
|
|
|
## Access to the Setup Pages in the Normal Operation mode
|
|
You always can access all the settings during the normal operation mode via the `Settings` menu:
|
|
|
|
{: style="width:500px"}
|
|
|
|
- `(1)` Access to the [General Settings](Configuration.md).
|
|
- `(2)` Update of the [Reference Image](Reference-Image.md).
|
|
- `(3)` Update of the [Alignment Marks](Alignment.md).
|
|
- `(4)/(5)` Update of the [ROIs](ROI-Configuration.md).
|