Initial Setup

After setting up the device (firmware, SD card, WLAN) the device will connect to the wifi access point and start in an initial setup configuration:

{: style="width:500px"}

With the buttons on the top you can navigate through 5 steps which guide you through the necessary setup:

Create the Reference Image. It is the base for the position referencing and the identification of the digits and counters.
Define two unique References. It is used to align the individual camera images and identify the absolut positions.
Define the Digital ROIs to be recognized. (Only required in case your meter has analoge pointers).
Define the Analog ROIs to be identified
General Settings. Most settings can be used with default value at the beginning.

All settings can be accessed also later in the normal operation mode.

!!! Note Don' t forget to save each step with "Save" and do not reboot at this stage.

Finish the Setup and change to the Normal Operation mode

With the last step (1) you leave the Setup Mode and reboot to the Normal Operation mode.

{: style="width:500px"}

You always can access all the settings during the normal operation mode via the Settings menu:

{: style="width:500px"}