From f1edaafb341023408e87c031f8ff37726c8ea4a4 Mon Sep 17 00:00:00 2001 From: CaCO3 Date: Tue, 21 Feb 2023 21:55:19 +0100 Subject: [PATCH] . --- docs/initial-setup.md | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/docs/initial-setup.md b/docs/initial-setup.md index 4fab69d..80ddc3f 100644 --- a/docs/initial-setup.md +++ b/docs/initial-setup.md @@ -7,10 +7,10 @@ After setting up the device (firmware, SD card, WLAN) the device will connect to With the buttons on the top you can navigate through 5 steps which guide you through the necessary setup: 1. Create the [Reference Image](Reference-Image.md). It is the base for the position referencing and the identification of the digits and counters. -1. Define two unique [References](Alignment.md). It is used to align the individual camera images and identify the absolut positions. -1. Define the [Digital ROIs](ROI-Configuration.md) to be recognized. (Only required in case your meter has analoge pointers). -1. Define the [Analog ROIs](ROI-Configuration.md) to be identified -1. [General Settings](Configuration.md). Most settings can be used with default value at the beginning. +1. Define two unique [Reference Marks](Alignment.md). They is used to align the individual camera images and identify the absolut positions. +1. Define [ROIs](ROI-Configuration.md) for the Digits. They will be used to digitize the digit part of your meter. If your meter has no digits, this step can be skipped. +1. Define [ROIs](ROI-Configuration.md) for the Analog Counters. (Only required in case your meter has analoge counters) +1. [General Settings](Configuration.md). Further configuration of your device. All settings can be accessed also later in the normal operation mode.